L-BOXX question
Activity
Sector experience since
not enabled
Sector
Electrical installation
Written on
I just bought a GSR 12V-15 FC and it came with an L-BOXX, with two inserts. The one that's holding the interchangeable heads and the holster (see attached picture) has a couple of empty compartments. I was wondering what I can fit in there. One's rectangular and seems like it might fit a bit set, the other seems molded for some tool, but I couldn't find any information about this. Is there a list somewhere of all the L-BOXX inserts and what tools/accessories they're compatible with?

The part number of the insert is 6.082.850.659.
Activity
Sector experience since
not enabled
Sector
Joinery installation in the broadest sense
Written on
Hello indrek.
Couldn't say for sure as the kits vary quite a lot, non quite looking a perfect match for the 2 inserts. The space you have where the chucks are stored is for the right angle chuck.
You're probably right in thinking the rectangular slot is for a bit set. These drill sets are often supplid with a bit set (see pic below).
The space above that looks like it might fit the GLI PocketLED. This is also something often supplied with the GSR 12V kit quite often.
Activity
Sector experience since
not enabled
Sector
Electrical installation
Written on
Thanks for the reply! I'll have to look at the different Bosch bit sets to see which ones have the proper dimensions, as none seem to be advertised as "L-BOXX compatible".

Alternatively, I'm thinking I don't need to carry around all the chuks, just the keyless one, and the drill's own slot can accommodate it. So I could replace the whole right-side insert with something that can hold various bits and maybe other tools. But it looks like the L-BOXX inset box sets cannot be divided so as to take up exactly half a box, so my best bet might be to get a foam insert and customise that.

Too bad there isn't an authoritative source for all the L-BOXX inserts and compatibility info...