L-Boxx removing of stickers?

Activity
Sector experience since
not enabled
Sector
Interior designer / Decorator
Written on
Ive just bought 3 Bosch power tools with L-BOXXs.
I want to remove the white security label on the corner and the coloured labels which were half peeling off.
Whats the best way to get them off and the glue residude they leave behind? Ive tried water, WD40 as suggested on another forum (left a oily mess) any ideas?
Dont understand why Bosch use such stickers? The printed coloured ones the edges are all peeling and the security corner one is stuck over the raised BOSCH logo on the catch so makes it a nightmare to remove

This post was edited by graham on 07.03.2021, 11:39 o’clock
Reason: spelling

Activity
Sector experience since
not enabled
Sector
Other woodworking
Written on
Isopropyl Alcohol - aka Isopropanol
Activity
Sector experience since
not enabled
Sector
Other woodworking
Written on
Or try "Sticky Stuff Remover" from Bettaware or similar from local hardware shops
Alternativley push the boat out and use "Zoff" from Chemists (Used for removing pink cloth "Elastoplast "and similar
Activity
Sector experience since
not enabled
Sector
Other woodworking
Written on
I have found the best way is a bit of gentle heat from something like a hairdryer to soften up the label glue, then VERY SLOWLY peel off.

If any residue left, give it a quick once over with the hairdryer and use a piece of the removed label to press onto the remaining glue, and it usually lifts it away completely.

Take your time and keep warning it up with the hairdryer and it will remove all the label and residue without leaving anything behind. Its a bit tedious, but this is the approach I have found that gets it all off cleanly.

Good luck!