Storage and transport
Storing tool elements (see figures R1–R6)
You can attach certain tool elements to the power tool to store them.
- Detach the additional parallel guide (52) from the parallel guide (8).
- Place all loose components of the tool in their storage compartments on the housing (see the following table).
Figure | Tool element | Storage compartment |
|---|---|---|
R1 | Protective cover (6) | Place in the recess on the bracket (22) and secure using the clamping lever (49) |
R2 | "Additional parallel guide" fastening set (39) | Clip into the brackets (80) |
R2 | Dust extraction adapter (41) | Slide into the holding clips (81) |
R3 | Unused saw blades | Place in the saw blade storage compartment (82) and fasten the cover (14) above it with the securing nut (12) |
R3 | Ring spanner (15) | Place in the saw blade storage compartment (82) and fasten the cover (14) above it with the securing nut (12) |
R3 | Push stick (13) | Attach with the securing nut (12) |
R4 | Hex key (37) | Slide into the brackets (83) |
R4 | Parallel guide (8) | Place in the parallel guide storage compartment (36) |
R5 | Angle guide (3) | Slide into the holding clips (23) |
R6 | Additional parallel guide (52) | Place in the additional parallel guide storage compartment and secure with the holding clip (84) |
Transporting the power tool
Before transporting the power tool, the following steps must be carried out:
- Bring the power tool into the transport position.
- Remove all accessories that cannot be securely fitted to the power tool.
If possible, transport unused saw blades in an enclosed container. - Slide the saw table expansion (11) in fully and push the clamping handle (18) downwards to secure it in place.
- Slide the saw table extension (10) all the way in and tighten the locking screws (38) on the guide bars (24).
- Wrap the power cable around the cable holder (42).
- Use the carrying handles (4) to lift or transport the tool.
- Only use the transport devices to transport the power tool and never the protective devices.