Changing the Tool

Push the locking sleeve (2) back and insert the application tool by turning it into the holder (1). Release the locking sleeve (2) to lock the application tool.

Push the locking sleeve (2) back and pull the application tool out of the holder.(1).

Remove the application tool.

Insert the adapter into the holder (1). Turn the locking ring (19) until it audibly clicks into place.

GFA 18-E/GFA 18-W (see figure C):

Push the locking sleeve (2) back and insert the application tool by turning it into the holder (1). Release the locking sleeve (2) to lock the application tool.

GFA 18-M/GFA 18-B/GFA 18-WM (see figure D):

Open the drill chuck adapter by turning it in the direction of rotation ❶ until the application tool can be inserted. Insert the application tool.

Firmly tighten the sleeve of the drill chuck adapter by turning it by hand in the direction of rotation ❷. This will automatically lock the drill chuck.

Pull the locked adapter approx. 5 mm away from the power tool. Turn the adapter to the required position and then let it go.

Remove the application tool.

Unlock the adapter in direction and pull it off the holder (1).