Assembly

Loosen the fastening screw (3) and fully fold out the tripod legs. Tighten the fastening screw firmly by hand.

Position the tripod on a fixed, level floor so that the middle column is vertical. Firmly fasten the worklight to the tripod head using the tripod screw (1).

Loosen the rotary fixings (2) on the telescopic shaft and extend the tripod to the required working height. Tighten the rotary fixings firmly by hand.

You can fasten a light cable using the cable clamp (6).

If necessary, you can store the tripod screw (1) in the opening (5).