Fitting the vacuuming accessories (see figure A)

The vacuum hose (16) is equipped with a clip system which can be used to connect vacuuming accessories (dust extraction adapter (14), curved nozzle (17)).

Fitting the nozzles and tubes

Push the curved nozzle (17) onto the vacuum hose (16) until you hear both snap fasteners (26) on the vacuum hose engage.
Then attach the required extraction accessory (floor nozzle, crevice nozzle, suction tube, etc.) firmly to the curved nozzle (17).
To remove the accessory, press the snap fasteners (26) inwards and pull apart the components.

Fitting the dust extraction adapter

GAS 15

Push the dust extraction adapter (14) onto the vacuum hose (16) until you hear both snap fasteners (26) on the vacuum hose engage.
To remove the adapter, press the snap fasteners (26) inwards and pull apart the components.