Adjusting bevel angles

The bevel angle can be set between 47° (left-hand side) and 47° (right-hand side).

For quick and precise setting of frequently used bevel angles, fixed positions have been provided for the angles 0°, 22.5° and 45°.

Make sure that the clamping wheel (45) is fitted see Fitting the Clamping Wheel (see figure A2).

Setting Standard Bevel Angles (see figure L)

Pull the adjustable fences (26) all the way out or remove them completely.
Release the clamping wheel (45).
Pull the locking lever (46) out and engage it in the free running position.
This enables you to use the complete bevel angle range (left and right).
Swivel the tool arm left or right by the handle (7) until the angle indicator (28) shows the required standard bevel angle.
Turn the locking lever (46). The locking lever must be felt to engage in the position of the required standard bevel angle.
Retighten the clamping wheel (45).

Pull the adjustable fences (26) all the way out or remove them completely.
Release the clamping wheel (45).
Pull the locking lever (46) out and engage it in the free running position.
This enables you to use the complete bevel angle range (left and right).
Swivel the tool arm left or right by the handle (7) until the angle indicator (28) shows the required bevel angle.
Retighten the clamping wheel (45).