Safety information for cordless worklights
Read all the safety information and instructions. Failure to observe the safety information and follow instructions may result in electric shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
- Please read and observe all safety and general instructions included with the battery or with the power tool supplied with the battery.
- Handle the worklight with care. The worklight produces intense heat which increases the risk of fire and explosion.
- Do not work with the worklight in potentially explosive areas.
- Do not continue to press the On/Off switch after the worklight has been automatically switched off. The battery can be damaged. Ensure that the battery is charged and that the worklight has cooled before switching on the worklight again.
- Use only original Bosch accessories.
- The light source cannot be replaced. If the light source is defective, the entire cordless worklight must be replaced.
- Remove the batteries from the worklight before carrying out any work on the worklight (e.g. assembly, maintenance, etc.) as well as when transporting and storing the worklight. There is risk of injury from unintentionally pressing the on/off switch.
- Do not direct the light beam at persons or animals and do not stare into the light beam yourself (even from a distance).
- Do not use the worklight in road traffic. The worklight is not permitted for illumination in road traffic.
Keep the minimum distance between the cordless worklight and all illuminated surfaces and objects. Illuminated objects may overheat if this distance is not maintained.
NOTE: Do not look into the light beam for prolonged periods. The optical radiation may harm your eyes. |
- Do not cover the lamp head while the cordless worklight is operating. The lamp head warms up during operation and can cause burns if this heat accumulates.