Technical Data
Mitre saw | GCM 254 | |
---|---|---|
Article number | 3 601 M52 0.. | |
Rated power input | W | 1750 |
No-load speed | min–1 | 5000 |
Laser type | nm | 650 |
mW | < 1 | |
Laser class | 2 | |
Weight according to EPTA-Procedure 01:2014 | kg | 11.1 |
Protection class | / II |
Permitted workpiece dimensions (maximum/minimum): see Permissible workpiece dimensions
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occasional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Zactual = 0.101 Ω. The user must make sure, that the connection point, with the impedance Zmax, on which the appliance shall be plugged in meets the impedance requirement: Zactual ≥ Zmax. If Zmax is unknown, determine Zmax in consultation with the network supplier or supply authority.
Values can vary depending upon the product and are subject to application and environmental conditions. For further information www.bosch-professional.com/wac.
Europe
Dimensions of suitable saw blades | ||
---|---|---|
Saw blade diameter | mm | 254 |
Base blade thickness | mm | 1.4–2.5 |
Max. cutting width | mm | 3 |
Hole diameter | mm | 30 |
Asia/Africa
Dimensions of suitable saw blades | ||
---|---|---|
Saw blade diameter | mm | 254 |
Base blade thickness | mm | 1.4–2.5 |
Max. cutting width | mm | 3 |
Hole diameter | mm | 25.4 |