Start-up

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Pay attention to the mains voltage! The voltage of the power source must match the voltage specified on the rating plate of the power tool. Power tools marked with 230 V can also be operated with 220 V.

To switch on the power tool, first slide the lock-off button (5) to the middle and then press and hold the on/off switch (19).

Note: For safety reasons, the on/off switch (19) cannot be locked; it must remain pressed during the entire operation.

To switch off, release the on/off switch (19).