Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Always firmly tighten the locking knob (12) and push the lock button down (13) before sawing. Otherwise the saw blade can become wedged in the workpiece.

Switching on (see figure L)

To start the power tool, first press the lock-off button (6). Then press the on/off switch (35) all the way in and keep it pressed.

Note: For safety reasons, the on/off switch (35) cannot be locked; it must remain pressed during the entire operation.

Switching off

To switch off, release the on/off switch (35).