Maintenance and Cleaning

Pull the plug out of the socket before carrying out any work on the power tool.

To ensure safe and efficient operation, always keep the power tool and the ventilation slots clean.

In order to avoid safety hazards, if the power supply cord needs to be replaced, this must be done by Bosch or by an after-sales service centre that is authorised to repair Bosch power tools.

The retracting blade guard must always be able to move freely and retract automatically. It is therefore important to keep the area around the retracting blade guard clean at all times.

Always remove dust and chips after working by blowing out with compressed air or using a brush.

Regularly clean the lighting and laser units((34), (19))

To clean the laser lens cap (16) fully unscrew the screw. Then, pull the cap out of the housing along the retracting blade guard (20). (see figure h)