Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Fold up the safety flap (21).
To start, press the green "on" button (70).

Press the safety flap (21).

The on/off switch acts as a zero-voltage switch that prevents the power tool from starting up again following a power outage (e.g. if the mains plug is removed during operation).
To restart the power tool following a power outage, press the green "on" button (70) again.

Start-up

Switching on (see figure I1)

Switching off (see figure I2)

Power outage