Transport (see figure Y)

Before transporting the power tool, the following steps must be carried out:

• Loosen the locking screw (6) if it is tightened. Pull the tool arm fully forwards and retighten the locking screw.
• Ensure that the depth stop (42) is swung all the way back and the adjusting screw (41) fits through the recess without touching the depth stop when you move the tool arm.
• Push the saw table extensions all the way in and fix them there.
• Bring the power tool into the transport position.
• Remove all accessories that cannot be securely fitted to the power tool.
• If possible, transport unused saw blades in an enclosed container.
• Tie the power cable and hook-and-loop strap (69) together.
• Carry the power tool by the transport handle (11) or grasp the recessed handles (30) on the side of the saw table