Adjusting mitre angles

Setting Standard Mitre Angles (see figure I)

For quick and precise setting of commonly used mitre angles, detents are provided on the saw table:

Left

Right

0°

45°; 30°; 22.5°; 15°

15°; 22.5°; 30°; 45°

  • Loosen the locking knob (15) if it is tightened.
  • Pull the lever (16) and rotate the saw table (12) left or right to the required detent.
  • Release the lever again. The lever must be felt to engage in the detent.
  • Retighten the locking knob (15).

Setting any Mitre Angle

The mitre angle can be set between 47° (left-hand side) and 47° (right-hand side).

  • Loosen the locking knob (15) if it is tightened.
  • Pull the lever (16), turn the saw table (12) left or right by the locking knob and set the required mitre angle using the angle indicator (17).
  • Retighten the locking knob (15).