Technical Data
Values can vary depending upon the product and are subject to application and environmental conditions. For further information www.bosch-professional.com/wac.
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Permissible workpiece dimensions (maximum/minimum): see Permissible workpiece dimensions
Europe
Mitre saw | GCM 216 | |
|---|---|---|
Article number | 3 601 M33 0.. | |
Rated power input | W | 1300 |
No-load speed | min–1 | 4800 |
Laser type | nm | 650 |
mW | < 1 | |
Laser class | 2 | |
Weight according to EPTA-Procedure 01:2014 | kg | 9.1 |
Protection class |
| |
Dimensions of suitable saw blades | ||
Saw blade diameter | mm | 216 |
Base blade thickness | mm | 1.4–1.8 |
Max. cutting width | mm | 3.3 |
Hole diameter | mm | 30 |
/ IIThe appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occasional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Zactual = 0.35 Ω. The user must make sure, that the connection point, with the impedance Zmax, on which the appliance shall be plugged in meets the impedance requirement: Zactual ≥ Zmax. If Zmax is unknown, determine Zmax in consultation with the network supplier or supply authority.
Asia/Africa
Mitre saw | GCM 216 | GCM 216 | |
|---|---|---|---|
Article number | 3 601 M33 0.. | 3 601 M33 080 | |
Rated power input | W | 1300 | 1300 |
No-load speed | min–1 | 4800 | 4800 |
Laser type | nm | 650 | 650 |
mW | < 1 | < 1 | |
Laser class | 2 | 2 | |
Weight according to EPTA-Procedure 01:2014 | kg | 9.1 | 9.1 |
Protection class |
|
| |
Dimensions of suitable saw blades | |||
Saw blade diameter | mm | 216 | 216 |
Base blade thickness | mm | 1.4–1.8 | 1.4–1.8 |
Max. cutting width | mm | 3.3 | 3.3 |
Hole diameter | mm | 30 | 25.4 |
The appliance meets IEC 61000-3-11 requirements and is subject to conditional connection. The appliance can lead to occasional voltage fluctuations under unfavorable power conditions. The impedance of this appliance is set as Zactual = 0.35 Ω. The user must make sure, that the connection point, with the impedance Zmax, on which the appliance shall be plugged in meets the impedance requirement: Zactual ≥ Zmax. If Zmax is unknown, determine Zmax in consultation with the network supplier or supply authority.