Operating modes
- Pull the plug out of the socket before carrying out any work on the power tool.
Adjusting the mitre/bevel angle (see figure D)
The base plate (7) can be swivelled to the right or left to make mitre cuts up to 45°.
The anti-splinter guard (15) cannot be used while mitre cuts are being made.
- Remove the anti-splinter guard (15).
- Loosen the screw (16) and push the base plate (7) slightly towards the mains cable.
- The base plate has lock-in points at 0° and 45° on the left and right so that precise mitre/bevel angles can be set. Swivel the base plate (7) to the desired position according to the scale (17). Other mitre/bevel angles can be adjusted using a protractor.
- Then push the base plate (7) towards the saw blade (10) as far as it will go.
- Retighten the screw (16).
Moving the base plate (see figure E)
You can move the base plate (7) back for sawing close to edges.
Fully unscrew the screw (16) using the hex key (4). Remove the screw together with the profiled plate (18).
Lift the base plate (7). Move the base plate towards the power cable so that the hole for sawing close to edges (22) is above the threaded hole in the power tool housing. The positioning cam (19) must engage in the opening (20) of the base plate at the same time. Insert the screw (16) along with the profiled plate (18) in the threaded hole and tighten the screw.
Sawing with an offset base plate (7) is only possible with a mitre/bevel angle of 0°. In addition, the parallel guide with circle cutter (25) (accessory) as well as the anti-splinter guard (15) must not be used.