Starting Operation
The rotational direction switch (3) is used to change the rotational direction of the power tool. However, this is not possible while the on/off switch (9) is being pressed.
Right rotation: To drive in screws and tighten nuts, press the rotational direction switch (3) through to the left stop.
Left Rotation: To loosen and unscrew screws and nuts, press the rotational direction switch (3) through to the right stop.
The user interface is used to preselect the speed and working mode and to indicate the status of the power tool.
Status indications
Status indicator for power tool (15) | Meaning/cause | Solution |
|---|---|---|
Green | Status OK | – |
Yellow | Critical temperature has been reached or rechargeable battery is almost empty | Run the power tool at no load and allow it to cool down, or replace or charge the battery soon |
Illuminated red | Power tool has overheated or rechargeable battery is empty | Allow the power tool to cool down, or replace or charge the battery |
Flashing blue | Power tool is connected to a mobile device or settings are being transferred | – |
With the speed preselection button (19), you can preselect the required speed in three stages. Press button (19) as often as needed until the required setting is indicated in the speed indicator (20). The selected setting will be saved.
You can also preselect the speed using the Bosch Toolbox app.
The required speed depends on the material and the working conditions; it can be ascertained through practical tests.
Basic speed setting at level | |||
|---|---|---|---|
1 | 2 | 3 | |
[min–1] | [min–1] | [min–1] | |
Number of speed settings | |||
3 | 0–800 | 0–2300 | 0–3400 |
You can use the button for speed preselection (19) to preselect the required speed, even during operation.
The power tool has two preset working modes A and B (16). You can also programme working modes for different applications and adjust existing modes via the Bosch Toolbox under A and B (16).
To switch between the working modes A and B (16), press the mode button (17).
Predefined working mode (16) | Meaning | Function |
|---|---|---|
A | Auto Slow-down | When using working mode A, the power tool reduces the speed when tightening (impact mechanism in action). The slow-down time can be adjusted via the controls in the Bosch Toolbox app. |
B | Auto Shut-off | When using working mode B, the power tool automatically stops as soon as the screw is screwed all the way in. The shut-off time can be adjusted via the controls in the Bosch Toolbox app. |
The user interface can be locked and unlocked using the "Lock User Interface" function in the Bosch Toolbox app.
Locking and unlocking through the user interface:
Activate the "(Un-)Lock from tool" function in the Bosch Toolbox app.
The function is now also enabled on the power tool.
To lock or unlock the user interface, press and hold both the mode button (17) and the speed selection button (19) for five seconds.
Note: If the "Lock User Interface" function is activated, the reset to factory settings option on the power tool is automatically deactivated.