Dry vacuuming

Extracting dust deposits

To switch on the dust extractor, set the mode selector switch (4) to the "On" symbol.
To switch off the dust extractor, set the mode selector switch (4) to the "Off" symbol.

Extracting dust that accumulates from working power tools (see figure B)

There must be a sufficient air exchange rate (L) in the room when the exhaust air comes back into the room. Be aware of the corresponding national regulations.

The dust extractor has a plug socket with a protective earth contact that can be used to connect an external power tool. Observe the maximum permitted connected load of the connected power tool.

Set the mode selector switch (4) to the "operation with remote automatic switching" symbol.

Different hose connection systems are available as accessories for power tools.

To start the dust extractor, switch on the power tool connected to the plug socket (5). The dust extractor will start automatically.
Switch the power tool off to switch off the dust extractor. The dust extractor automatically switches off approx. 6 seconds later.