Starting Operation

To switch on the power tool, press the on/off switch (6).
The user interface lights up.
If single actuation is activated, the (26) indicator lights up.

Switch on the power tool.
Firmly position the outlet (15) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (2) is pressed down completely.
The worklight switches on and the motor starts.
Afterwards, briefly press the trigger (5) and release it again.
This discharges a staple.
Allow the power tool to bounce back from the workpiece.
For another driving procedure, completely lift the power tool from the workpiece and position it firmly at the next required location.

Switch on the power tool.
Activate the contact actuation by briefly pressing the mode button (25).
The contact actuation display (27) lights up white.
Press and hold the trigger (5).
The worklight switches on during this process and the motor starts.
Firmly position the outlet (15) or the rubber workpiece protector (1) on the workpiece until the discharge lock-off (2) is pressed down completely.
This discharges a staple.
For another discharging procedure, keep the trigger (5) pressed and completely lift the power tool from the workpiece. Replace it firmly in the next required position.
Switch to single actuation by pressing the mode button (25) again.
The single actuation indicator (26) lights up.

Switching On and Off