Working Advice
- For all cuts, it must first be ensured that the saw blade at no time can come in contact with the fence, screw clamps or other machine parts. Remove any mounted auxiliary stops or adjust them accordingly.
Protect the saw blade against impact and shock. Do not subject the saw blade to lateral pressure.
Do not saw warped/bent workpieces. The workpiece must always have a straight edge to face against the fence.
A laser beam shows you the cutting line of the saw blade. This allows for exact positioning of the workpiece for sawing, without having to open the retracting blade guard.
- To activate this, turn on the laser beam using the switch (36).
- Align your mark on the workpiece with the right-hand edge of the laser line.
- Before sawing, check whether the cutting line is still indicated correctly. The laser beam can be misplaced due to vibrations from intensive use, for example.
Maximum workpiece dimensions:
Mitre angle | Bevel angle | Height x width [mm] |
|---|---|---|
0° | 0° | 95 x 150 |
45° (right/left) | 0° | 95 x 90 |
0° | 45° | 60 x 150 |
45° (left) | 45° | 60 x 60 |
45° (right) | 45° | 60 x 100 |
Minimum workpiece dimensions (= all workpieces that can be secured left or right of the saw blade using a screw clamp):
200 x 40 mm (length x width)
Maximum cutting depth (0°/0°): 90 mm
The red insert plate (24) can become worn after long use of the power tool.
Replace faulty insert plates.
- Bring the power tool into the mitre saw work position.
- Unscrew the screws (49) using a cross-headed screwdriver and remove the old insert plate.
- Insert the new insert plate and screw all the screws (49) in tight again.
- Adjust the bevel angle to 0° and saw a slot in the insert plate.
- Then, adjust the bevel angle to 45° and saw in the slot again. This process ensures that the insert plate is as close as possible to the saw blade teeth without touching them.